Parabody 848101 Bedienungsanleitung

848101 LAT OPTIONPart # 6826701Revision: 5/26/991ASSEMBLY INSTRUCTIONS

10STEP 9:FIGURE 9 23 3/8 X 2”191920 911 2• Route the end of the second CABLE (9) through the slot on the UPRIGHT (2) then SECURELY assemble on

11STEP 10:FIGURE 10• SECURELY assemble the CABLE (9) to the BASE (1) using one 3/8 X 4-1/2” BOLT (26), one 3/8 X 1” SPACER (32), and one 3/8” LOCKNU

12STEP 11:FIGURE 11• Attach the LAT BAR (6) to the ball end of the upper CABLE (9) using one 5/16” SNAP HOOK (28) as shown in FIGURE 11.• Attach

STEP 12:FIGURE 12• Tilt the 848101 back and remove the STAND (3) as shown in FIGURE 12.• To use the 848101 LAT OPTION: (NOTE: LAT OPTION MUST BE

Thank you for purchasing the Parabody 848101 LAT OPTION. If unsure of proper use of equipment, callyour local Parabody distributor or call the Parabod

Please note:Tools Required for Assembly* Thank you for purchasing the Parabody 848101 LAT OPTION. Please read these instructionsthoroughly and keep th

3PARTS LISTPART #6824303682370368254036824103682550262753026274402654240268248013103102311620161770016405201646700166926016825101KEY123456789101112131

FIGURE 1STEP 1:• SECURELY assemble the one 3/8 X 2-3/4” BOLT (25), two 3/8” WASHERS (19), and one 3/8” LOCK NUT (20) to the STAND (3) asshown in FI

5FIGURE 4STEP 3:• Assemble one 17-1/2” FOAM STRIP (16) to the underside of the CROSS BRACE (4) as shown in FIGURE 3.• Assemble two 2-1/2 X 5-1/2” N

6STEP 5:FIGURE 501234561/2 1/2 1/2 1/2 1/2 1/2• Slide the CARRIAGE (5) over the UPRIGHT (2) asshown in FIGURE 5.• Assemble the STAND (3) to the

STEP 6:FIGURE 6• SECURELY assemble the BASE (1) to the UPRIGHT (2) using one 1/2 X 3” BOLT (27), two 1/2” WASHERS (21) (slide front washerINSIDE of

8STEP 7:FIGURE 701234561/2 1/2 1/2 1/2 1/2 1/2• Route the CABLE (9) through the UPRIGHT (2) as shown in FIGURE 7.• SECURELY assemble three 3-1/2

9STEP 8:FIGURE 8 23 3/8 X 2”191920 9 829 2 5• Place one 3-1/2” PULLEY (11) into the loop of the CABLE (9) below the second and third PULLEY of th